Tres has your basic guide to installing trex transcend deck railing.
Trex stair tread installation.
When the treads are installed this cut will make the bottom step the same height as the others.
Stair tread steps or stairway boards that are the steps.
Deckboard on the nose of the stair tread.
1 25mm if installing in localities prone to large temperature shifts within a 24 hour period and installing trex universal hidden fasteners predrill and toenail a screw use same screw used in hidden fasteners at an angle in groove at both ends at least 1 25mm from board end and center of each board.
Trex select railings are designed to be installed over the decking frame or on inside of rim joist.
Hope you all enjoy.
At the bottom step subtract the thickness of a tread from the rise and mark a line perpendicular to the rise.
Universal fastener plastic 6 mm self gapping hidden fastener that has increased durability and allows for easier and faster installation than traditional fasteners.
Snap baluster spacer into bottom stair rail and lay bottom stair rail on top of the deckboard 5.
Place inverted 2 x 4 51 mm x 102 mm place top side down on clean flat surface.
Use the lower and upper stair post to set the length of the bottom stair rail.
Heavy duty treads and landing are welded to a round collar that precisely slides over the 3 1 2 diameter center pole.
Start clip metal clips used at the end of decking boards to secure them in position.
This is the stair video.
Trex select stair railing installation instructions important notes.
Want to install beautiful stair railing for your deck.
If using aluminum balusters use a scrap piece of wood measuring at least 1 11 16 thick and place on the nose of the stair tread.
100 composite with no visible pressure treated wood on the stairs.
Ships with a 10 x 1 4 thick round metal base plate with pre drilled holes for bolting to landing pad.
Treads and landing are pre drilled to receive trex tread board.
Notching of pressure treated posts or posts installed on outside of rim joist is not allowed.
For more videos and installation.
Prior to installing posts calculate post to post span using a maximum rail.
Make sure 53 135 6 cm posts are used for all stair posts.
Unique lip up tread design for added strength and safety.
Ensure that baluster spacer holes are.
Place universal rail remembering to orient this properly so that when flipped over the universal rail will accept the baluster spacer and balusters on the 2 x 4 51 mm x 102 mm centered.
If trex signature stair posts are used install at nose of stair tread directly under required blocking.
Installing standard trex signature stair posts trex signature stair crossover posts or pressure treated post post sleeves and skirts 1.
Part 4 of our deck series.