The swt01259 limit switch is used on many trane and american standard furnaces.
Trane fan limit switch.
The high temp limit switches usually have a manual reset button that needs to be pressed to reset.
I have a trane xe 80 and my high temp limit switch open led flashing light code appeared.
This is used so that cold air is not blown into a house waiting for the gas flames to heat up enough before the blower turns on.
Fan limit switch q a 5 furnace fan limit control troubleshooting.
I changed out the filters and it started up again.
The specifications on the furnace limit switch are thermal limit open 190 f close 160 deg f.
I did some research and thought it was due to a clogged filter.
This means that this limit switch opens and cuts off the gas burners when the temperature inside the furnace heat exchanger reaches 190 f and closes back to allow the burners to come back on when the heat exchanger reaches a temperature of 160 degrees f.
I would try a reset it may have been a fluke that it tripped if the reset dosent trip again it is probably fine.