This wire is what s actually searched for if the pipe itself needs to be located hence the name.
Tracer wire for water pipes.
Tracer wire which is also called locating wire or locator wire is used to assist in locating pipes and other lines after they ve been buried in the ground.
The tracer wire should be placed in the same orientation to all installed pipe.
Recommended 2 6 separation.
Once a pipe is laid down tracer wire is placed along it s length and buried next to the pipe.
Splicing of wire if necessary shall be done in such a way to produce an electrically and mechanically sound connection.
Underground tracer wire is used to accurately locate underground pipes and lines.
Trace wire on north side of water main pipe 4 way connector or two 3 way connectors with short jumperwire water main typ cross main mainline tolateral lug connector typ grade level water service typ in ground trace wire access box and drive in magnesium grounding anode see water servicedetail.
The tracer wire shall be laid within 6 inches of the plastic pipe where practical and directly above if possible.
Tracer wire should not be wrapped around pipe or connectors except at the riser.
Using a spacer taping the tracer wire to the pipe every 8 10 feet in the three o clock position or specifying fill between the pipe and tracer wire are all acceptable practices.
The red wire is for electric.
A coated copper clad steel tracer wire of 12 gauge or larger kub item 300362 shall be installed with all buried plastic mains and services.
Contact with the pipe is allowed but shall be minimized.
Other lengths and gauges of tracer wire available.
Install tracer wire along the pipe above or to the side of the pipe.
100m roll of 1 5mm blue tracer wire locator.
The wire is laid alongside the pipes or lines during installation in order to find them at a later date for safe digging.
The coating is normally polyethylene the same.
Ansi gptc install tracer wire as a single continuous wire.
New tracer wire designed specifically for underground use is no longer solid copper but copper clad steel for better strength to prevent breakage.